95 www.opm.fi LiveFix 360 transducer mount Patriot® LiveFix 360 is a aluminum, sturdy transducer holder for live sonar use. Thanks to the very versatile adjustment and fastening possibilities, Patriot® LiveFix is suitable for installation on almost all types of boats. The Patriot® LiveFix 360 transducer holder is designed to be installed either on a rail, firmly bolted to the deck, or on a mounting rail (rail mount optional). Thanks to the adjustment grooves in the mounting table of the holder it is possible to adjust the mounting point and distance of the stand to the optimum for different type of boats. Thanks to sufficient adjustments, Patriot® LiveFix is also suitable for installation on most boats with wider edges, such as Buster, Silver and Faster. The versatile adjustments and adaptability of the Patriot® LiveFix 360 transducer holder allow the mount to be installed on both smaller and slightly larger boats. The shaft is made of aluminum, so it is very easy to work on and, if necessary, shorten it to just the right size for smaller boats. In standard size, the shaft is long enough (150cm) to reach below the bottom line even in slightly larger and higher boats. It is also easy to adjust the height of the shaft by raising it slightly upwards, so that, for example, turning the stand from the casting platform in a fishing situation can be done without reaching far. The carefully considered features and details of the Patriot® LiveFix 360 make using the holder very easy. When lowering the rack to the lower position, the holder shaft locks into its own supported bracket and a light tightening of the locking lever is sufficient. When in the lower position, the shaft stays firmly in the frame, and does not get twisted and warped, but the holder always stays in the right position. When searching for fish and underwater structures with the live sonar, the rotation resistance of the transducer holder can be fine-tuned using the adjustment nut at the upper end of the holder. The long enough and very visible handle helps to easily detect the direction of the sonar even from a little further away. When lifting the transducer holder up to the transport position, it is securely locked horizontally to rest on the mounting table, after which a light tightening of the locking levers is sufficient. It is possible to completely remove the holder shaft from the mounting table during storage and transport, so that no other parts get stuck to the boat. The holder shaft can also be turned inside the boat for protection, for example during trailering. Patriot® LiveFix 360 is designed for use with, for example, Lowrance Active Target, Garmin Panoptix Livescope and Humminbird Mega Live sonars. • Sturdy and light aluminum construction • Versatile adjustment and attachment options • Sturdy 10mm thick aluminum mounting table with adjustment grooves • In the lower position, the holder shaft locks into the support bracket and always stays in the correct position • In the upper position, the shaft is securely locked horizontally against the mounting table • Quick-release locking lever for quick and easy use • Can be installed on a railing, platform or rail (rail bracket optional) • Included fixing accessories for railing installation (25mm / 1” rail) • Detachable pointer handle • The holder shaft can be removed, leaving only the mounting table in the boat • The holder shaft can be turned inside the boat, for example during trailering • Steplessly adjustable height • Continuously adjustable rotation resistance • Total length of holder shaft 150cm • The transducer holder is designed to be shortened to a suitable length for each boat • Holder shaft diameter 25mm / 1” • The inner tube structure allows the cable to be attached to the outer tube • Bolts and fasteners made of stainless steel • Suitable for installation on almost all types of boats • Designed for use with, for example, Lowrance Active Target, Garmin Panoptix Livescope and Humminbird Mega Live sonars 5-5013 Trolling and boat accessories
RkJQdWJsaXNoZXIy MjU0MzgwNw==